QJ9 (EP-9) Electric Helicopter

 


This is the new Hard 3-D anodized heli kit, see the features page that shows upgrades that come in the kit!

Size:  (approx. 33 inches long), ( approx. 11 inches height), (approx. 3 feet rotor Dia.)

To see the Quality of this EX Kit, click on the manual !

This is a slightly larger heli than the EX and it uses standard size servos with constant tail rotor drive!

       

      Features

      Manual

      Parts

      Photos

      Options         

                

 

  

 

              Motors

        ESC's

        Servos

        Batt &charger

 

Recommended Setups
Click Below for Setup Specs

Hardcore 3D

Serious 3D

Hi-Performance

Entry Level / Beginner
The New Kit Box for the EP8v2 EX.Spec sheet to show the approx. 3 Feet Main Rotor Diameter and 33 inch length.Quality and Japanese Precision are shown by leaving parts out of the bags. It has following specs: (EP9 kit)

1.tail shaft ( 5.0mm )
2.tail grip bearing(  2 pcs)
3.tail pc lever ( bigger 2 bearings)
4.main frames(  2.0mm )
5.rudder servo (  standard size )
6.oneway bearing ( bigger size )
7.main shaft [8.0mm (all the way, no cuts)]
8.swash bearing(  2 pcs)
9.washout arm ( strong type same as 30 class)
10.main grip ( 2 radial bearings to 2 radial bearings with 1 thrust )
11.stabilizer bar ( 325 mm for 3D )
12.anodized blue color (standard )